Life Stick initial setting Remote Control Pairing and Re-pairing

Button name on remote control

  • TS201/TS302
  • TS401
[Microphone button]
Press to search by voice while the home screen or the corresponding menu is displaying.
[Cursor button]
Select items and move the cursor.
[Enter button]
Determine the selected item.
[Play / Pause button]
Press this button while watching the video content to start / pause.
[Home Button]
Return to the home screen.
[Return button]
Return to the previous screen.

About the remote control battery

  • Battery type(TS201)

    • ※ Before using, be sure to open the back cover of the remote control and remove the insulating tape.
      ※ If the battery is discharged, please replace it for a new one.
      ※ Use 2 CR-2032 button batteries.

  • Rechargeable type(TS302)

    • [How to charge the remote control]
      To charge the remote control, connect the LifeStick main unit microUSB cable to the remote control. The LED lamp blinks blue during charging.

      ※ Before using the remote control, disconnect the AC adapter power cable from the main unit, connect it to the remote control to charge it.
      ※ The USB terminal of the AC adapter is only chargning the remote control.
      ※When the battery is low, the LED on the tip will blink red.
      Charge the remote control.
      ※Charging will take about 2 hours and 30 minutes.

  • Battery type(TS401)

    • ※ If the battery is discharged, please replace it for a new one.
      ※ Requires two AAA batteries.

If you can't find Life Stick in your room

From the residents exclusive website「&Leo」select 「サポート・LEONET に関するご質問」(Support/Questions about LEONET)from「LEONETを楽しむ」(Enjoy LEONET), then from the category list select 「Life Stick」→「Life Stickについて」(About Life Stick)→「お申し込みはこちら」(Apply here)to ask for a new device.
※ "LEONET ID" and "password" are required for the procedure.
※ Life Stick can not be used in ISDN line properties, so you cannot apply.
※ Please note that even if you have not applied for Life Stick, you will be charged for the services you have subscribed to.

Remote controller pairing.

Pairing the remote controller and the Life Stick.
※ Depending on the Life Stick version the screen design and steps may differ.

  1. Press the 「Back」and 「Home」buttons simultaneously.
  2. Long press until the message to release the buttons appears 「ボタンから手をはなしてお待ちください。」.
  3. Press the select button. (Following steps only for TS401 version)
  4. The Android TV screen will appear.
  5. Select your language.
  6. Choose 「Use wired LAN connection」and press continue.
  • TS201/TS302
  • TS401

Regarding the pairing of the remote controller.

For the [TS201][TS302] versions:

  1. Press the ◁ and ◯ buttons on the remote control at the same time and check that the tip of the remote control is blinking blue.
  2. Place the remote control near the Life Stick unit, disconnect the power adapter from the power outlet, and then reconnect it.

For the [TS401] version:

  1. Press the "RESET" button on the side of the LifeStick main device with a thin tip to display the pairing screen on the TV screen.
  2. Place the Life Stick remote control near the Life Stick main device, and press and hold the ← and buttons at the same time to re-pair.